APP Download #
Scan QR code or click button to download “WLED Native” app
Características #
- 4-channel individual control
- Compatible with various IC
- 100 kinds of dynamic mode with music synchronization
- Built-in Microphone with special WLED APP control
- Over current (15A) protection
- Firmware updating simply via WLED APP ( wireless solution) or UART terminal(wired solution)
Parámetros #
| Nº de modelo. | ESP02 | ESP04 |
| Canal de salida | 2 | 4 |
| Tensión de entrada | DC5V-24V | |
| Voltaje de entrada tipo C | 5 V CC | |
| Corriente de salida | Máximo 15 A | |
| Píxel | 1024/ Canal | |
| Control Protocol | WiFi | |
| IP Rate: | IP20 | |
| Working Temp. | -20~45°C | |
Diagrama de conexión #
ESP02
V+ → LED strip VCC
GND → LED strip GND
IO4 / IO12 → LED strip DATA
IO13 → Extended GPIO output (defined by user)
ESP04
V+ → LED strip VCC
GND → LED strip GND
IO4 / IO16 / IO12 / IO2 → LED strip DATA
IO13 → Extended GPIO output (defined by user)
APP Configuration #
1. Power on WLED controller
2. Connect with “IMLTLED-WLED-AP” in WLAN setting of your phone. (password: wled1234)
3. The WLED PAGE will come out automatically once connecting completed. If it does not display automatically, please enter into http://4.3.2.1 from browser
4. Click “WIFI SETTINGS”
5. Click “Scan”
6. Select wifi network, tap into password and click ”Save& connect”
7. Ensure your phone and controller in the same network, enter into WLED APP to get controller in device list.
LED Strip Configuration #
Open the WLED control page → Config → LED Preferences → Program LED strip.
Relay Configuration #
Open the WLED control page → Config → LED Preferences → Set Relay GPIO = 18, enable Invert, and tap Save.
Note:
When the lighting fixtures is turned off via the app, remote control, or push switch, the power supply of output terminals will be cut off to save energy.
Please note that this function is not used for auxiliary (supplementary) power supply.
