Features #
- This product is made by 2.4G wireless transmitting technology with low consumption and strong ability to resist signal loss.
- 5 kinds of output mode support 5 led strip (Single color/CCT/RGB/RGBW/RGB+CCT)
- Support 2.4G remote control.
Parameters #
| Model No. | iH5 | iM5 |
| Input | DC12V-24V | DC12V-24V |
| Output | 8A/Channel | 6A/Channel |
| Total output | Max 20A | Max 12A |
| RF | 2.4GHz | WiFi+2.4GHz |
| Control distance | 30m | 30m |
| Working temperature | -20~45°C | -20~45°C |
| Product Size | 110*39*20mm (L*W*H) | 91*38.5*17mm (L*W*H) |
Input 1
Input 2 (DC5521 Max 10A)
Indicator
SET button
Output
Connection Diagram #
For single color led strip (short press “SET”–white indicator)
For dual white led strip (short press “SET”– yellow indicator)
For RGB led strip (short press “SET”–red indicator)
For RGBW led strip (short press “SET”–green indicator)
For RGB+CCT led strip (short press “SET”–blue indicator)
Output mode settings #
Short press (SET) continuously to select output mode, indicator displays different output modes as following diagram.
| Indicator | Output |
| White | Single color |
| Yellow | Dual white |
| Red | RGB |
| Green | RGBW |
| Blue | RGB+CCT |
Setting PWM frequency #
Long press “SET”until indicator flashes, short press “SET” continuously to select PWM frequency.
| Lowest | Flashing slowly | Flashing quickly | Fastest |
| 250Hz | 2KHz | 4KHz | 8KHz |
PWM frequency (changing different frequency to solve the noise problem from power adapter).
High frequency only support device with lower wattage, low frequency support device with higher wattage and have better dimming performance. Factory default PWM frequency is 4KHz.
Dynamic Mode List (For remote control only) #
Attention: brightness, saturation and speed are dimmable
| No. | Dynamic mode |
| 1 | Automatical color changing |
| 2 | RGB gradual changing |
| 3 | Color changing randomly |
| 4 | Seven color jumping |
| 5 | Color jumping randomly |
| 6 | Volcano red |
| 7 | Forest green |
| 8 | Ocean blue |
9 | Three color jumping and gradual changing |
Mini Brightness #
- Long press “
” or “ 
” in group zone 6 seconds until light flashes one time. - Short press “ ” or “ ” in group zone to set up 10 kinds of brightness level ( 1%, 5%, 10%, 15%, 20%, 25%, 30%, 35%, 40%, 50%).
” or “ 
” in group zone 6 seconds until light flashes one time. Short press any button except “OFF” to confirm or step out setting, the master “OFF”can set up all features.
ON/OFF Time #
The light status changes gradually (factory default time is 0.5s).
1.5s: Short press “ON” 1 times and short press “OFF” 5 times within 3 seconds, the setting is done once light flashes 2 times slowly.
0.5s: Short press “OFF” 1 times and short press “ON” 5 times within 3 seconds, the setting is done once light flashes 2 times quickly.
Attention #
- Please cut off power before wiring device
- Please check the voltage of power adapter before connecting
- Don’t disassemble it if you are not expert
- Don’t use it in metallic or magnetic area